GulfCoat IEA-OC-008 Printed Board Circuit Shield Aerosol preventative anti corrosion spray Conformal Coating 12.5 oz acts as a Circuit Shield to prevent rust Modine Use: Designed for all types of circuit boards as a corrosion inhibitorDetails: A thin polymeric film which conforms to printed circuit board characteristics. Nonconductive, protective dielectric layer applied to printed circuit boardDetails: Conformal coatings are known to protect against extreme or harsh environments. Protects against moisture, dust and chemicalsDetails: Features chemical resistance. Adheres well to printed circuit board and components that populate the boardCorrosion Resistance: Corrosion and pests can reduce performance and ruin Printed Circuit Boards. A proper conformal coating for this equipment will enhance its ability to remain efficient throughout its life cycleWeight : 1.08 LBRVolume : 0.03 FTQModel : IEA-OC-008UPC-EAN : 850021531065 Conformal Coating Application Instructions Specifications When properly applied by directions, Circuit Shield™ spray coating process should ensure a uniform dry film thickness of 25-50 μm (1.0 – 2.0 mils) and meet 5B rating for crosshatch adhesion per ASTM D3359. Corrosion durability shall be confirmed through testing to no less than 2,500 hours salt spray resistance per DIN 53167 (ASTM B117) using aluminum test coupons. Dielectric Withstanding Voltage test shall pass at 1500 volts/mil thickness.Circuit Shield™ Applications HVAC/R Printed Circuit Boards (PCB)Elevator Control PanelsTelephone Communication BoxesOutdoor Timers and SwitchesTraffic Lighting and Rail Crossing Control PanelsAutomotive, Heavy-Duty Truck &; Off-Highway EquipmentCircuit Shield™ Features Excellent moisture resistanceMold &; mildew resistanceSuperior adhesionSupports dielectric propertiesUV resistant qualitiesDirections Surface must be free of grease, rust and wax. Prior to coating, follow these steps: Use an approved cleaner for PCBs.Allow circuit board to thoroughly dry.Mask off or protect areas from overspray.Allow can to warm to room temperature.Shake until mixing ball rattles, then continue to shake for two minutes. Coating must be applied above 50ºF (10ºC).3-Step Application Move can and apply coating to the entire board with overlapping strokes left and right, keeping spray pattern vertical. Allow paint to become tacky.Move can and apply coating to the entire board with overlapping strokes up and down, keeping spray pattern horizontal. Allow paint to become tacky.Move can and apply coating to the entire board with overlapping strokes left and right, keeping spray pattern vertical.After use, invert can and spray to clear valve. Prestalia e-commerce solutions.